Lasko model comparisons
Lasko Motion X CC27350 vs Motion Heat Plus CC23161
The CC27350 Motion X and CC23161 Motion Heat Plus are both black Lasko ceramic consoles with three heat levels, a separate fan-only mode, a remote and two kinds of powered movement. The practical differences are their body shapes, timer lengths, documented sweep details and lock controls. Neither product’s advertised square-foot coverage is a guarantee that it will heat a particular room evenly.
Start with the shape, not the “whole room” label
Lasko lists the CC27350 at 26.49 inches high, 7 inches wide and 11 inches deep. The CC23161 is listed at 22.58 inches high, 10.77 inches wide and 7.59 inches deep. The Motion X is taller and deeper but narrower; whether that profile fits depends on the actual placement area, not just one dimension. Weight is not a reliable tie-breaker: the CC27350 product page says 8.5 pounds while its native variant record says 8,165 grams, and the CC23161 page and variant record also disagree. Both weights should be treated as unresolved.
Lasko lists 300 square feet for the CC27350 and 200 square feet for the CC23161. Those are maximum coverage claims from the manufacturer, not independently measured room results. Choose a heater for the room and routine you can actually accommodate, and keep the required open clearance in mind.
The Motion X specifies more about its movement
Both manuals document separate movement at the base and outlet area. For the CC27350, Lasko lists 72 degrees of horizontal oscillation and 20 degrees of vertical grille movement. The CC23161 sources document base movement and powered vertical louvers but give no numeric arc. If a minimum horizontal sweep angle is essential, the CC27350’s number can be compared with that threshold; do not infer a number for the CC23161. Neither maker specification proves even heat throughout a room.
Timer and lock details can change the choice
The CC27350 has a countdown of up to twelve hours, compared with eight hours for the CC23161. On both, it is an automatic shutoff timer, not a delayed-start schedule. The CC27350 manual also describes a child lock: it blocks heater functions except Power and leaves currently active functions running. The CC23161 product page does not list a control lock, so do not assume one. In any case, neither the lock nor the countdown makes unattended operation acceptable; both manuals warn against leaving these heaters running without supervision.
Both models document three heat settings and a fan-only mode. Their listed overall wattage ranges do not map a particular wattage to each heat level. If you need exact low-mode power draw, these sources do not provide it. The CC27350 manual explains an Auto Eco sequence that uses High below the target, Low around the target, then shuts the heat off above it. Read the CC23161 manual for its own described thresholds rather than assuming the controls behave identically.
Placement remains the deciding constraint
The exact manuals call for a stable, level floor position, direct wall power and generous combustible clearances—three feet in front and one foot at each side and the rear. They prohibit extension cords and power strips, bathroom or damp-area use, and unattended operation. Check your clearances after choosing a spot; the body dimensions alone do not define a usable setup.
Prefer the CC27350 when the taller console fits and its 72-degree horizontal figure, longer shutdown countdown or lock behavior matters. Consider the shorter CC23161 when its lower listed body height and eight-hour timer suit your setup better. Review the Motion X CC27350 assessment and Motion Heat Plus CC23161 assessment alongside their current manufacturer manuals before deciding.