Your needs, this model
Does it fit your priorities?
Will the Tower Heater 718 run a fan without heating?
Yes. The manual lists a separate fan-only mode with low, medium and high speeds. It circulates room air; it does not cool it.
Explore this need in the finder →Can the 718 fit under a 30-inch height limit?
Its listed body height is 29.7 inches. Leave the front and sides clear as the manual directs, and measure the complete operating spot rather than only the body.
Explore this need in the finder →Can the 718 start automatically before I enter the room?
The manual documents a 0–12-hour auto-off timer, not a delayed start. If a later start is essential, the MC706 manual documents a timer for turning the appliance on or off.
Explore this need in the finder →The DREO Tower Heater 718 is the straightforward choice in this three-model group: a 29.7-inch, 8-pound ceramic tower that heats, oscillates and can run its fan without heat. Its useful distinction is not an unusually large heater rating; it is the shorter body and selectable sweep in a conventional heater layout. The maker’s US manual identifies it as DR-HSH008 and rates it for 120 volts and 1,500 watts.
Five heat steps give you more than high and low
The DR-HSH008 manual lists five power-heat settings: 700, 900, 1,100, 1,300 and 1,500 watts. ECO mode adjusts its output around a 41–95°F set temperature, while fan-only mode circulates room air with three selectable speeds. That is enough control for someone choosing between a low setting, full output and a target temperature without navigating a larger fan interface.
These are operating controls, not evidence that a particular room will reach its target quickly. DREO’s product page publishes a coverage figure, but real heating depends on the room, insulation, drafts, outlet and starting temperature. Treat the published maximum wattage as a model fact, not a promise that one portable heater will replace a home’s main heating system.
Choose it for a moderate-height tower, not a full fan replacement
The control panel and included remote set the 718 apart from a basic dial heater, and its fan-only mode is useful outside the heating season. The manual gives three fan speeds—low, medium and high—and lets you choose 30°, 60°, 90° or 120° oscillation. The default sweep is 60°. That breadth is helpful if the heater needs to face more than one seated position, but a selected angle is not a measurement of the space it can heat evenly.
There is no basis to call the 718 an air conditioner. Fan-only operation moves the air already in the room; it does not refrigerate or lower the room’s temperature. If you want a tower fan with a broader set of warm-weather airflow patterns, the MC706 has 12 fan-only speeds and Normal, Natural, Sleep and Auto modes. The tradeoff is a taller 42.46-inch body and a larger footprint.
Set the timer expectation correctly
The manual describes an automatic shutoff timer from zero to 12 hours. It does not establish a scheduled start from the off position. That difference matters if your plan is to have the unit begin heating before you enter a room: choose a model whose manual documents delayed start, rather than reading “timer” as a universal promise. In this group, the MC706 manual documents a timer for turning the appliance on or off; the 718’s instructions describe auto-off.
The 718 also has a child-lock function and a mute control for its button sounds. Those controls change how the heater is operated; they do not change its placement requirements or make unattended heating appropriate. If app control is essential, this review does not treat a remote as equivalent. The reviewed 718 material does not establish phone-app operation.
Plan the floor position and outlet before buying
The US manual says not to use this heater outdoors and to keep combustible items—including furniture, bedding, papers, clothes and curtains—at least three feet from the front, while keeping them away from the sides and rear. Place it on a stable, level surface. The manual also says to plug directly into a wall receptacle, not an extension cord or power strip, and not to cover the heater or block its inlet and outlet. Measure the route through the door and the location of the outlet, not just the floor space beside a chair.
For cleaning, switch off, unplug and allow the heater to cool. DREO’s instructions call for a soft cloth and discourage cleaning agents; do not let water enter the motor housing. Keep the cord clear of traffic and inspect the plug and cord before use. These simple requirements can rule out a location even when the heater itself fits.
Where the 718 fits among the three
Choose the 718 if you want five documented heat levels, an ECO thermostat, a simple three-speed fan-only mode and a 120° maximum oscillation in a 29.7-inch tower. It is the more compact height choice over the MC706, although the Solaris Max (2nd Gen.) is shorter on its published dimensions. Choose the MC706 if 12 fan speeds, Natural/Sleep/Auto airflow or a documented scheduled start are essential and the 42-inch tower fits your room. Consider the Solaris Max when the shorter body and a 70° sweep suit the space better, but do not choose it to satisfy a particular per-level wattage or fan-speed requirement that its current documentation does not establish.
Use the finder’s indoor choice first. A 30-inch height limit includes the 718, while an essential request for a 12-speed fan or a later start does not. That is the practical line between a capable compact heater and a more involved all-season fan-and-heater tower.
Key details at a glance
| Maximum listed input | 1500 W |
|---|---|
| US supply voltage | 120 V |
| Published body height | 29.7 in |
| Published body width | 7.9 in |
| Published body depth | 7.9 in |
| Published body weight | 8 lb |
| Installation form | Floor-standing and movable |
| Power-heat levels | 5 |
| Listed wattage values | 700 / 900 / 1100 / 1300 / 1500 W |
| Separate fan-only mode | Yes |
| Documented fan-only speeds | 3 |
| Maximum documented horizontal sweep | 120° |
| Temperature setting range | 41–95°F |
| Timer behavior | Manual describes automatic shutoff from 0 to 12 hours. |
| Can the heater start on a timer? | No |
| Fanless convection heating | No |
| Control lock | Yes |
Use the exact model’s instructions for operating limits, supplied equipment and version differences.
Sources for this assessment
- DREO Tower Heater 718 US product page
- DREO US heater collection native product record for 718
- DREO Tower Heater 718 product data
- DREO PTC Fan Heater Solaris 718 user manual, DR-HSH008
- CPSC Recalls Retrieval Web Services Programmer’s Guide
- CPSC recall database exact DREO heater/model query (no matching recall record returned)
- CPSC recall database exact DREO heater/model query (no matching recall record returned)
- CPSC recall database exact DREO heater/model query (no matching recall record returned)
Check whether the room and routine line up.
Check room restrictions and full wall clearances first, then compare fan-only versus fanless heat, fit, app controls and the timer behavior the exact manual describes.
